Use this cable to connect the following products to the VE.Bus BMS:– Skylla-TG all models The cable translates the remote on/off driver logic from the VE.Bus BMS (normally high, and open circuit in case of alarm) to the logic needed by above products: active pull down to switch off.
Non-inverting remote on-off cable Read More »
The MPPT WireBox provides an extra level of safety, and is particularly useful if your MPPT Solar Charger is installed in a general access area. It covers all DC terminals, preventing accidental or inquisitive contact with terminal screws. There are various sizes available:MPPT WireBox-S 75-10/15MPPT WireBox-S 100-15MPPT WireBox-S 100-20MPPT WireBox-M 100-30/50 & 150/35MPPT WireBox-L Tr
MPPT Wire Box – Tr Read More »
with 30A ATO fuse The MagCode Power Clip is an accessory of the Blue Smart IP65 Charger with DC connector. This accessory is compatible with the following IP65 chargers: 6V/12V/1.1A, 12V/4A, 12V/5A, 12V/7A, 12V/10A, 12V/15A, 24V/5A, 24V/8A, 24V/13A
MagCode Power Clip Read More »
The M6/M8 eyelet connector with fuse is an accessory of the Blue Power & Blue Smart IP65 Charger with DC connector. Blue Smart IP65 Chargers This accessory is compatible with the following IP65 chargers: 6V/12V/1.1A, 12V/4A, 12V/5A, 12V/7A, 12V/10A, 12V/15A, 24V/5A, 24V/8A, 24V/13A
M6 and M8 Eyelet Connector Read More »
Use this cable to connect the (discontinued) Phoenix Inverter 12/180, 24/180, 12/350 or 24/350 to a VE.Bus BMS or a BlueSolar MPPT Charger that features a load output:
Inverting remote on-off cable Read More »
The EV Charging Station NS has three-phase and single-phase capabilities. It delivers a maximum of 22kW AC in three-phase or 7.3kW in single-phase mode. The device is technically identical to the EV Charging Station, but with a new, modern design available in 3 colours and without the built-in LCD screen. Initial setup, configuration and monitoring
EV Charging Station NS Read More »
Energy Meters are typically used in an Energy Storage System, to measure the power and energy of the whole application at the distribution box. Also they can be used to measure the output of a PV Inverter, to display the data on GX device such as the Cerbo GX and the VRM Portal. There are several models available from Victron, see
Energy Meters VM-3P75CT, ET112, ET340, EM24 Ethernet & EM540 Read More »
The Connect clamps with fuse is an accessory of the Blue Power & Blue Smart IP65 Charger with DC connector. Blue Smart IP65 Chargers This accessory is compatible with the following IP65 chargers: 6V/12V/1.1A, 12V/4A, 12V/5A, 12V/7A, 12V/10A, 12V/15A, 24V/5A, 24V/8A, 24V/13A
Voltage and Temperature sense The battery indicator panel shows the status of the battery. It is an accessory for the Blue Smart IP65 Charger and the Blue Power IP65 Charger. Suitable for 12V lead acid batteries (flooded, GEL, AGM) Blue Smart IP65 Chargers This accessory is compatible with the following IP65 chargers: 6V/12V/1.1A, 12V/4A, 12V/5A,
Battery Indicator Panel Read More »
The Battery Indicator Eyelet M8 is an accessory for the Blue Power IP65 Chargers and the Blue Smart IP65 Chargers. Blue Smart IP65 Chargers This accessory is compatible with the following IP65 chargers: 6V/12V/1.1A, 12V/4A, 12V/5A, 12V/7A, 12V/10A, 12V/15A, 24V/5A, 24V/8A, 24V/13A
Battery Indicator Eyelet M8 Read More »
